Owon SDS Series User Manual download pdf (Page 89)

6.Communication with PC

Using LAN Port

Connect directly

(1) Connection. Plug in the LAN line to the LAN port in the right side panel of the

oscilloscope; plug the other end into the LAN interface of the computer.

(2) Set the network parameters of the computer. Since the oscilloscope can not

support obtaining an IP address automatically, you should assign a static IP address.

Here we set the IP address to 192.168.1.71.

Figure 6-2 Set the network parameters of the computer

(3) Set the network parameters of the OWON Oscilloscope Software. Run the

software on the computer; choose the "Ports-settings" of the "Communications" menu

item. Set "Connect using" to LAN. About the IP, the first three bytes is same as the IP

in the step (2), the last byte should be different. Here, we set it to 192.168.1.72. The

range of the port value is 0～4000, but the port which under 2000 is always be used,

so it is suggested to set it to the value above 2000. Here, we set it to 3000.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 108 109

No comments

Owon SDS Series User Manual Page 89