Owon VDS Series User Manual download pdf (Page 29)

12.How to do Pass/Fail test

The Pass/Fail function monitors changes of signals and output pass or fail signals by comparing the input signal that is within the pre-defined

mask.

Click to show Function menu, choose "Pass/Fail".

Detect whether the input signal is within the limits of the rule, if it exceeds limits of the rule, it is "Fail"; otherwise it is "Pass". Also it can output fail

or pass signal by built-in and configurable output port.

To run the test, read the following steps:

1.Choose channel: Options include CH1,CH2 and Math。

2.Set horizontal tolerance and vertical tolerance. You can adjust by or input directly.

3.Click "Create Rule".

4.Set output type: Choose "Pass" or "Fail". Check or uncheck "Ring", "Message Show" and "Stop Once" as needed.

Ring: The bell rings when it meets the rule.

Stop Once: Stop once it meets the rule.

Message Show: Display the counting message on the left top.

5.Enable switch on: Click "Enable".

6.Begin to test: Click "Run".

7.Stop testing: Click "Stop".

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Comments to this Manuals

No comments

Owon VDS Series User Manual Page 29

Comments to this Manuals